::Semester Wrap-up	2009-01-07 19:54:48 | TMSTKSBK
	So close! ...so very, very far. Semester is coming to a close once again. This semester was actually pretty fun. I only had one really bad test (so far). One test to go, and three projects to do. GC 350 Project: This is a very fun class overall, and the project is no exception. My project consists of 20 individual types of part that are collectively assembled into a grinder vise. Like GC 120, this class uses Solidworks. The focus is getting tolerances right. Deliverables: - 20 solid models of parts. - 1 part assembly (one of the parts is compound) - 1 model assembly - Technical drawings (from Solidworks) of each non-standard part - Hand sketches of each part, and of the overall assembly. Can't use straightedge or protractor/compass. - Technical drawing of overall assembly. ENG 331 Project: This class isn't bad. Lot of writing involved (I wonder why...?). Project is to create a ~10pg proposal on something. I chose a project from Sony Ericsson. Easier to write if I've already done it >_< :P. Really there's only one *deliverable* here -- the proposal itself. With front and back matter, my proposal is 17 pages long. Yay. ST 370 Project: Heh. We're going to test the speed of ice melting in various substances at various temperatures. We had to think of something >_>. AND THEN IT'S FINALS! GC 350 Final Worry Level (of 10): 6.5 ST 370 FWL: 8 CSC 230 FWL: 7 I'm really not that worried about GC. I'm pretty sure I'll do ok on that final. CSC final should be relatively simple. The ST final I need to do relatively well on to get an A... Meh. See you later.
>>View Comments